Ask a Question

Interference pattern is observed at ‘P’ due to superimposition of two rays coming out

from a source ‘S’ as shown in the figure.The value of ‘’ for which maxima is

obtained at ‘P’ is : (R is perfect reflecting surface) :

- Option 1)
- Option 2)
- Option 3)
- Option 4)

The circuit has two oppositely connect ideal diodes in parallel. What is the current following in the circuit?

- Option 1)
1.33 A

- Option 2)
1.71 A

- Option 3)
2.00 A

- Option 4)
2.31 A.

As we have learnt,

P -N junction as diode -

It is a one way device. It offers a low resistance when forward biased and high resistance when reverse biased.

- wherein

R = 0, Forward

R Reverse

In the figure D, is reverse biased, hence no current will flow through D.

Option 1)

1.33 A

Option 2)1.71 A

2.00 A

Option 4)2.31 A.

298 Views

In a full wave rectifier circuit operating from 50 Hz mains frequency, the fundamental frequency in the ripple would be

- Option 1)
100 Hz

- Option 2)
70.7 Hz

- Option 3)
50 Hz

- Option 4)
25 Hz

As we have learnt,

Full wave rectifier -

It is type of rectification in which output is obtained for both the halves of a.c.

- wherein

Frequency of output is double to that of input

In full wave rectifier

Input Output

Time period becomes half

Frequency gets doubled

Frequency is 100 Hz

**Option 1)**

**100 Hz**

Option 2)

70.7 Hz

Option 3)

50 Hz

Option 4)

25 Hz

267 Views

If in a junction diode, a square input signal of 10 V is applied as shown

Then the output signal across will be

- Option 1)
- Option 2)
- Option 3)
- Option 4)

As we have learnt,

P -N junction as diode -

It is a one way device. It offers a low resistance when forward biased and high resistance when reverse biased.

- wherein

R = 0, Forward

R Reverse

When input is -5V, then diode is reverse biased and hence output is zero

When input is +5V, then output is also +5V

**Option 1)**

Option 2)

Option 3)

Option 4)

239 Views

The machine as shown has 2 rods of length 1 m connected by a pivot at the top. The end of one rod is connected to the floor by a stationary pivot and the end of the other rod has a roller that rolls along the floor in a slot. As the roller goes back and forth, a 2 kg weight moves up and down. If the roller is moving towards right at a constant speed, the weight moves up with a :

- Option 1)
constant speed

- Option 2)
decreasing speed

- Option 3)
increasing speed

- Option 4)
speed which is th of that of the roller when the weight is 0.4 m above the ground

From

dx /dt = constant

As with motion of roller , x decreases

dy/dt decreases

weight will move with decreasing speed

Option 1)

constant speed

**Option 2)**

** decreasing speed**

Option 3)

increasing speed

Option 4)

speed which is th of that of the roller when the weight is 0.4 m above the ground

475 Views

A line drawn through the point P(4, 7) cuts the circle x^{2}+y^{2}=9 at the points A and B. Then PA⋅PB is equal to :

- Option 1)
53

- Option 2)
56

- Option 3)
74

- Option 4)
65

As we learnt

Length of a tangent -

- wherein

Length of tangent from a external point to circle

Since we know,

Option 1)

53

**Option 2)**

**56**

Option 3)

74

Option 4)

65

159 Views

A spring of unstretched length *l* has a mass m with one end fixed to a rigid support. Assuming spring to be made of a uniform wire, the kinetic energy possessed by it if its free end is pulled with uniform velocity is :

- Option 1)
- Option 2)
- Option 3)
- Option 4)

As we have learned

Kinetic energy -

- wherein

Kinetic Energy is always positive.

fixed end is at rest and free end is moving with speed v

Velocity at distance x from free end

Kinetic energy of mass dm at x = x is K.E =

Total kinetic energy =

Option 1)

Option 2)

Option 3)

**Option 4)**

137 Views

Two soap bubbles coalesce to form a single bubble. If V is the subsequent change in volume of contained air and S the change in total surface area, T is the surface tension and P atmospheric pressure, which of the following relation is correct ?

- Option 1)
- Option 2)
- Option 3)
- Option 4)

As we have learned

Change in Pressure of bubble in air -

- wherein

T- Temperature

R- Radius

Option 1)

**Option 2)**

Option 3)

Option 4)

655 Views

A tank with a small hole at the bottom has been filled with water and kerosene (specific gravity 0.8). The height of water is 3 m and that of kerosene 2 m. When the hole is opened the velocity of fluid coming out from it is nearly : (take g=10 ms^{-2} and density of water =10^{3} kg m^{-3})

- Option 1)
10.7 ms

^{-1} - Option 2)
9.6 ms

^{-1} - Option 3)
8.5 ms

^{-1} - Option 4)
7.6 ms

^{-1}

As we have learned

Torricelli's Theorem / Velocity of Efflux -

In fluid dynamics relating the speed of fluid flowing out of an orifice.

- wherein

According to torcellli theorem

velocity of efflux =

Left density of water is

Density of kerosene = 0. 8

Apply bernoulli between A and B

Option 1)

10.7 ms^{-1}

Option 2)

9.6 ms^{-1}

**Option 3)**

**8.5 ms ^{-1}**

Option 4)

7.6 ms^{-1}

90 Views

A cylindrical vessel of cross-section A contains water to a height h.There is a hole in the bottom of radius 'a'.The time in which it will be emptied is :

- Option 1)
- Option 2)
- Option 3)
- Option 4)

As we have learned

Torricelli's Theorem / Velocity of Efflux -

In fluid dynamics relating the speed of fluid flowing out of an orifice.

- wherein

Velocity of eflux of water =

Option 1)

**Option 2)**

Option 3)

Option 4)

132 Views

The figure shows a system of two concentric spheres of radii and kept at temperatures respectively. The radial rate of flow of heat in a substance between the two concentric spheres is proportional to

- Option 1)
- Option 2)
- Option 3)
- Option 4)

As we have learned

Thermal Conductivity -

K = thermal conductivity

- wherein

Rate of flow of heat

We have a spherical shell of radius r and thickness dx

**Option 1)**

Option 2)

Option 3)

Option 4)

96 Views

Water is flowing at a speed of 1.5 ms^{-1 }through a horizontal tube of cross-sectional area 10^{-2} m^{2} and you are trying to stop the flow by your palm. Assuming that the water stops immediately after hitting the palm, the minimum force that you must exert should be (density of water=10^{3} kgm^{-3}).

- Option 1)
15 N

- Option 2)
22.5 N

- Option 3)
33.7

- Option 4)
45 N

As we have learned

Equation of Continuity -

Mass of the liquid entering per second at A = mass of the liquid leaving per second at B.

a_{1} v_{1} = a_{2} v_{2}

- wherein

a_{1} and a_{2 }be the area of cross section.

Let us say speed of water is v and area of cross section is A

In one second mass of water that flows is

F = momentum change per second

Option 1)

15 N

**Option 2)**

**22.5 N**

Option 3)

33.7

Option 4)

45 N

124 Views

An open glass tube is immersed in mercury in such a way that a length of 8 cm extends above the mercury level. The open end of the tube is then closed and sealed and the tube is raised vertically up by additional 46 cm. What will be length of the air column above mercury in the tube now ?

(Atmospheric pressure =76 cm of Hg)

- Option 1)
16 cm

- Option 2)
22 cm

- Option 3)
38 cm

- Option 4)
6 cm

As We have learned

Absolute Pressure -

- wherein

For air trapped in tube T = constant

**Option 1)**

**16 cm**

Option 2)

22 cm

Option 3)

38 cm

Option 4)

6 cm

132 Views

A thin bar of length L has a mass per unit length, that increases linearly with distance from one end.If its total mass is M and its mass per unit length at the lighter end is , then the distance of the centre of mass from the lighter end is :

- Option 1)
- Option 2)
- Option 3)
- Option 4)

As we have learned

Centre of Mass of a continuous Distribution -

- wherein

dm is mass of small element. x, y, z are coordinates of dm part.

k is some constant

Total mass =

From equation (1)

Option 1)

Option 2)

Option 3)

**Option 4)**

90 Views

A hoop of radius r and mass m rotating with an angular velocity is placed on a rough horizontal surface. The initial velocity of the centre of the hoop is zero. What will be the velociy of the centre of the hoop when it ceases to slip ?

- Option 1)
- Option 2)
- Option 3)
- Option 4)

As we have learned

Law of conservation of angular moment -

- wherein

If net torque is zero

i.e.

angular momentum is conserved only when external torque is zero .

When loop ceases to slip

angular momentum is conserved about point of contact P

L of c.m + L about C.M

= 0 + Iw =

L of cm + L about C.M

= Mvr +

Option 1)

Option 2)

Option 3)

**Option 4)**

71 Views

Exams

Articles

Questions

As we have learned

Lloyd's mirror Experiment -

- wherein

minima

maxima

For maxima at P

Or

or

Option 1)

Option 2)

Option 3)Option 4)